2.5" Polished Aluminum Sensor Pipe

This Pipe Can Fit Lots of MAP Sensors. The Pipe is 2.5" O.D., 9" Long. with 50x50mm Aluminum Flange Welded on, Sensor Opening is 30mm.

You Can Drill Mounting Holes to Match You Specific Application.

The Pipe Can be Welded to Your Existing Piping, or Use The Hoses and Clamps Come With it.

This Kit Comes With 1 Pipe, 2 Hoses, and 4 Clamps
 
 
 

Write a review

Please login or register to review

2.5" Polished Aluminum Sensor Pipe , 2.5" O.D., 9" Long. with 2 hoses and 4 clamps Tube

  • Brand: CXRacing
  • Product Code: PIP250-SEN-KIT
  • Availability: In Stock
  • $36.35


  • Emissions Control Warning:
  • It is illegal to sell, install, or offer for sale any aftermarket part that alters or modifies the original design or performance of the motor vehicle pollution control system. Product(s) listed here is(are) solely for Competition Vehicles(race vehicles) that are for Off-Road, Track Racing ONLY. All parts are for use on a vehicle that will NEVER be used, or licensed, or registered for use upon a street and highway. DO NOT Purchase the part(s) if you are intending to use it(them) on a Street/Highway vehicle(s).

  • All Products by CXRACING are solely for Competition Vehicles(race vehicles) that are for Off-Road, Track Racing ONLY. All parts are for used on a vehicle that will NEVER be used, or licensed, or registered for use upon a street and highway. DO NOT Purchase the part(s) if you are intending to use it(them) on a Street/Highway vehicle(s).

  • PROPOSITION 65 WARNING

  • These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warnings.ca.gov.