Browse Categories
Find by Competition/Race Car For Competition Trucks Engine Swaps Coilovers
CXRacing Header/Manifold + Downpipe Kit For 1979-1993 Fox Body Ford Mustang with GM LS1 Engine Swap

Supports T4 Turbo with 3" Vband Exhaust Housing

Perfectly Merged Collector, Supports Dual 46mm Vband Wastegate.

2.5" Cross Pipe Runs Under the Pulley, Cleaner Setup and Look.

3" Stainless Steel Downpipe

Comes with:
Turbo Headers + Cross Pipe + Downpipe + Wastegate Dump Tube

Notes:

1. This Kit Is For Turbo Header/Manifold Kit ONLY, It Is Part of CXRacing's Complete LS1 Swap Kit, Some Installed Pictures Shown Below Have Other Parts from The Complete Kit, But NOT All Parts Are Included for This Aution. We Offer Many Different Combinations, Please Check Our Other Products.

2. Need to Work On the Exhaust System to Connect to the Downpipe (Due to Many Exhaust Options, The Downpipe Is NOT Connected to Stock Exhaust).

3. There Is NO Installation Guide Provided, However, We Show Many Installed Pictures On Car and On Engine Stand.
This Product was developed based on US model Left-Hand-Drive chassis. For Right-Hand-Drive, due to potential conflict with steering shaft, fitment most likely will be an issue and we don’t guarantee fitment. Modification is needed and we won’t accept return due to Right-Hand-Drive fitment issues.

Application:

Chassis: 1979-1993 Ford Mustang
Motor: LS1

Product Being Sold:
Turbo Headers + Cross Pipe + Downpipe + WG Dump Tube

Note: Turbo, Wastegates, Intercooler and Piping Kit, Engine/Transmission Mounts Kit, Radiator Kit, Oil Pan Are NOT Included.

Product Info and Spec:

Headers/Manifold Kit:
304 Stainless Steel Headers, 1.65" Runners
With 2.5" Cross Pipe
Bolt On Fit, No Need To Cut or Relocate Other Parts
3" Stainless Downpipe

Notes:

Off Road or Track Use ONLY, NOT for Street Use.

Due to The Complexity of Swapping a Motor to Different Chassis, Please Make Sure that You Understand the Application Stated Here are the Right Parts for Your Project.

Parts Being Sold are The Kit Being Advertised ONLY. Other Parts Shown On Pictures are For Demo Only (of Our Complete Swap Kit). Check Our Other Prodcuts.

　 　 　 　 　 　 　 　

　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 39 　 　 　 　 　 　 　 　 　

Write a review

Please login or register to review

Turbo Header Manifold Downpipe Kit For 79-93 Ford Mustang LS1 LSx Swap

  • Brand: CXRacing
  • Product Code: MF-KIT-LS-MSTG7993-ONLY
  • Availability: In Stock

  • $1,227.00


0 reviews / Write a review

  • Emission Notes:

  • All Parts and services offered by CXRACING are for competition vehicles only. Use on State and Federal Highways may be a violation of the EPA Clean Air Act. The Clean Air Act can be found at http://www.epa.gov/air/caa/. This document contains in detail what are considered to be violations of the CAA and corresponding penalties for failure to obey and should be read in full before purchasing or installing this competition use only product. Ensuring that all emissions, noise/sound, and speed/use related laws are followed is the responsibility of the Buyer(s). Installation and use of this product indicates that this disclaimer has been read, acknowledged, and understood fully by both the Buyer(s) and Installer(s). The Buyer(s) assumes all associated risk of the purchase.

  • Federal and several state laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. CXRacing assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer’s modifications and/or use of CXRacing products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.

  • PROPOSITION 65 WARNING

  • These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warnings.ca.gov.