CXRacing Manifold + Downpipe + Wastegate Dump Tube For 04-06 Pontiac GTO LS1 LS2 with Twin Turbo Application.

Fits T4 Turbo with 3" Vband Exhaust Outlet and 46mm Vband Wastegate

This Kit Is Part of the Complete Turbo Kit Developed By CXRacing Specifically For the GTO. Keeps Factory Engine Accessories. It is Developed From A 2004 GTO Chassis, Fits Stock Chassis with Only Few Modifications. Needs to Use 2004 GTO LS1 Radiator, Does NOT Fit 05-06 LS2 Radiator.

For RHD Holden Monaro, We Have Not Tested, But the Only Potential Issue Is the Right Side Downpipe Might Hit Steering Shaft. We've Considered This and Made the Downpipe As Much Possible to Avoid Fitment Problem.

Few Parts Need to Relocate Or Modify:
1. Battery Needs to Be Relocated to Back Trunk (Not Included, Can be Purchased Separately)
2. Coolant Reservoir Needs to Be Replaced with Smaller Tank
3. Left Side Behind Headlight Area Needs to Be Trimmed Slight to Fit Turbo Air Filter

Note:
This is For Manifold + Turbo Elbow + Downpipe + WG Dump Tube ONLY. Other Parts of the Turbo Kit Shown on Pictures are For Demonstration of Fitment Only, They Are Not Included. We Offer Them Separately, Please Check Out Other Products.

Application:
Chassis: 2004-2006 Pontiac GTO
Motor: LS1, LS2

Product Being Sold:
Manifold + Turbo Elbow + Downpipe + WG Dump Tube

This is CXRacing's Newest Products for the Application Stated Above. All Parts Are Developed from Ground Up in Our R&D Center in USA, Designed and Built for Improved Performance Gains, with Excellent Fitment and Easy Installation.

This Product was developed based on US model Left-Hand-Drive chassis. For Right-Hand-Drive, due to potential conflict with steering shaft, fitment most likely will be an issue and we don’t guarantee fitment. Modification is needed and we won’t accept return due to Right-Hand-Drive fitment issues.

Product Info and Spec:

Manifolds:
1.65" OD Runners
Uses T4-To-3"Vband Stainless Elbow, Offers Better Fitment Flexibility
Fits Factory Accessories, AC ETC.

Downpipe:
2.5" Enlarge to 3" Downpipe
Downpipes Are Made Based on the Chassis We Had, They Are Built to Connect to the Appears Catback Position. See Pictures.

Notes:

-Off Road or Track Use ONLY, NOT for Street Use.

-Due to the Complexity of Swapping a Motor to Different Chassis, Please Make Sure that You Understand the Application Stated Here are the Right Parts for Your Project.

-Parts Being Sold are the Kit Being Advertised ONLY. Other Parts Shown on Pictures are for Demo Only (of Our Complete Swap Kit). Check Our Other Products.

　 　 　 　 Click Below Picture to Play Installed Car Video: 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 See Below Modifications/Relocations