Crank Sensor + Connector / Wiring Plug Assembly Kit for GM Gen III LSx Engines (LS1/LS6/LQ4, and early LS2) with a 24x (24 tooth) Crankshaft Reluctor Wheel.

Note: NOT for Gen IV LS Engine (LS3/LS7/LS9, and later LS2) with 58x Tooth Crankshaft Reluctor Wheel.

What's in the box?
This is for the Sensor and Connector ONLY, All Other Parts Shown Are NOT INCLUDED.

PRODUCT(S):
Sensor x1
Connector x1

Installed Photo:



 

Write a review

Please login or register to review

Crank Sensor Connector for Gen3 LSx Engines LS1/LS6/LQ4 LS2 24x Tooth Crankshaft Reluctor Wheel

  • Brand: CXRacing
  • Product Code: SEN-LS-CRANK-CONNECTOR
  • Availability: In Stock
  • $27.30


  • Emissions Control Warning:
  • It is illegal to sell, install, or offer for sale any aftermarket part that alters or modifies the original design or performance of the motor vehicle pollution control system. Product(s) listed here is(are) solely for Competition Vehicles(race vehicles) that are for Off-Road, Track Racing ONLY. All parts are for use on a vehicle that will NEVER be used, or licensed, or registered for use upon a street and highway. DO NOT Purchase the part(s) if you are intending to use it(them) on a Street/Highway vehicle(s).

  • All Products by CXRACING are solely for Competition Vehicles(race vehicles) that are for Off-Road, Track Racing ONLY. All parts are for used on a vehicle that will NEVER be used, or licensed, or registered for use upon a street and highway. DO NOT Purchase the part(s) if you are intending to use it(them) on a Street/Highway vehicle(s).

  • PROPOSITION 65 WARNING

  • These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warnings.ca.gov.